TDS raw data missing grade, elevation fields in stake-to-line and offset staking
Hi folks,
So, we staked a job using our Ranger data collector with Survey Pro software, and all was great until the last 4 shots.
For one of the good stakeouts, the raw data looks like this:
–STAKE TO LINE
–LINE: DEFINED BY: 65,64
SP,PN1072,N 4977.382296,E 5121.555729,EL1236.442874,–SET 60D
CF,ST-4.015295,OD1,OL0.010187,EL1236.443,GD1241.146
SK,OP1006,FP1072,AR357.595200,ZE125.020095,SD13.880000,–SET 60DAnother good one looks like this:
–OFFSET STAKING
–LINE: DEFINED BY: 69,68
SP,PN1075,N 4980.699882,E 5118.473424,EL1236.055762,–SET 60D
CF,ST4.000000,OD1,OL4.000000,EL1236.056,GD1243.670
OE,ST4.0,OE0.0118
DE,PN,N 4980.714206,E 5118.476294,EL1243.670000,–
SD,ND0.014324,ED0.0029,LD7.614238
SK,OP1006,FP1075,AR358.240800,ZE117.435393,SD17.955000,–SET 60DThe last 4 shots are all like this:
–OFFSET STAKING
–LINE: DEFINED BY: 73,74
SP,PN1082,N 4954.755378,E 5054.236540,EL,–SET 60D
CF,ST0.000000,OD2,OL4.000000,EL,GD
OE,ST0.0,OE0.0046
DE,PN,N 4954.745062,E 5054.243598,EL,–
SD,ND-0.010317,ED0.0071,LD
SK,OP1007,FP1082,AR349.542400,ZE100.150591,SD23.420000,–SET 60DNotice the CF,ST… line has no elevation and no grade.
Has anyone seen this? Is there some toggle that we accidentally hit? This is messing with my hand-rolled cut sheet lisp routine…
TIA,
Randy
Log in to reply.