Trimble Access – Calibration “Details Incomplete”
Ran into a problem I’m having trouble figuring out.
I started a new job last week and I thought I started it in state plane, but turns out it was no projection no datum. Not a problem since I was collecting static and planned to move everything to the opus position anyway.
So today I found out the project needs to be on a local coordinate system. I got the data sheet for a monument and went out and did a 1-point calibration on it. I only need to use this for horizontal, vertical I’ll use the opus elevation. I applied the 1-point calibration and then checked a couple points to make sure everything still checked, and they did.
Now here is maybe where I made a mistake… When I got back to the office I went back in and changed the elevation on the point I collected the static on from the here elevation to the opus elevation. This wipes out the 1-point calibration so I went back in and tried to create the horizontal only calibration again, but when I try to apply the information I get a pop-up saying “details incomplete” and I’m unable to proceed.
Has anyone encountered something like this before? Any tips on how to make this work would be appreciated.
Log in to reply.