Question: How do we can manage an error when we are setting loops for a big property – Traverse?
Last week, I was setting 4 loops for a large property 33,000 m square by Leica Total Station with existing controls on the street, when I was doing setup BS = 150m, FS= 140m – 160m, the error between each setup < 4mm, ~10 setups for each loop. When I check the controls in the same loop, the traverse error is around 4mm for each closure loop, but when I do check 4 loops together, the results are 20cm 50cm 60cm error. I’ve already used GPS – RTK stream to tie in the controls
Log in to reply.